Setup > Network Settings - Linksys SRW224G4P User Manual

Chapter 
System Information
Seral Number The serial number of the Switch is
displayed .
Model Name The model name of the Switch is
displayed .
Hardware verson
The current hardware version is
displayed .
Boot Verson The current boot version is displayed .
Frmware Verson The current software version is
displayed .
System Locaton Displays the location of the system if it
has been defined .
System Contact
The name of the administrator will
appear here if it has been defined .
System Uptme Length of time the management agent
has been up .
Current Tme Displays the current time .
PoE Information
Maxmum Avalable Power
power that can be supplied to a connected PoE device .
System Operaton Status
Displays the operational status
of the Power over Ethernet mechanism .
Manpower Consumpton
of watts that the Switch is providing to PoE devices .
Setup > Network Settings
Setup > Network Settings
The Network Settings screen allows you to edit the
following information .
24-Port 10/100 + 4-Port Ggabt Swtch wth WebVew and Power over Ethernet
Displays the maximum
Displays the current number
Configuring the Switch
Identification
System Name Specifies the name of the Switch . Enter
the name into the text field provided . By default, a system
name is not defined .
System Locaton
This field is used for entering a
description of where the Switch is located, such as 3rd
floor .
System Contact Enter the name of the administrator
responsible for the system .
Object ID The system object identifier is displayed here .
Base MAC Address Physical address of a device mapped
to this interface .
IP Configuration
To manually configure IP settings, you need to set an IP
address and subnet mask compatible with your network .
You may also need to establish a default gateway between
the Switch and management stations that exist on another
network segment .
An IP address may be used for management access to the
Switch over your network . You may also need to establish
a default gateway between the Switch and management
stations that exist on another network segment .
Management VLAN ID of the configured VLAN (1-4094,
no leading zeroes) . By default, all ports on the Switch are
members of VLAN 1 . However, the management station
can be attached to a port belonging to any VLAN, as long
as that VLAN has been assigned an IP address .
IP Address Mode Specifies whether IP functionality is
enabled via manual configuration (Static), Dynamic Host
Configuration Protocol (DHCP), or Boot Protocol (BOOTP) .
NOTE: If DHCP/BOOTP is enabled, IP will not
function until a reply has been received from the
server . Requests will be broadcast periodically
by the Switch for an IP address . If the mode is
set to DHCP/BOOTP and a server is not available,
you can reconfigure the settings by connecting
the console interface directly to a computer .
Select the IP Address Mode using the drop-down
menu . Selecting Static will allow you to enter a static IP
address, subnet mask and default gateway using the text
field provided . Selecting BOOTP or DHCP disables these
text boxes and auto assigns an IP address . The default
setting is Statc .
Host Name
Assign a host name to the Switch .
1