Figure 5-6: System Tab-Username/Password Setting - Linksys SRW224 User Manual

24-port 10/100 + 2-Port Gigabit Switch with WebView
Collision Retry Forever. In a collision, a packet will be re-sent until it reaches its destination. To enable this
feature, select Enable from the drop-down menu. To disable this feature, select Disable.
MAC Table Auto-Aging. If there is no response froma network device when searching for a MAC address within
the chosen time, the switch will remove the MAC address from the MAC address table. Select 150 sec, 300 sec, or
600 sec from the drop-down menu. To disable this feature, select Disable.
MAC Table Hashing. Select from a choice of two algorithm type used to check the MAC address table to determine
which MAC address is associated with what port or destination on the network. Select Direct Map or CRC
(Cyclical Redundancy Checking) Hash from the drop-down menu.
Console Auto Logout Time. The console will log out after the chosen time. Select 5 min, 10 min, or 20 min from
the drop-down menu. Select Never to disable the feature.
Web Auto Logout Time. The Web interface will log out after the chosen time. Select 5 min, 10 min, or 20 min from
the drop-down menu.
Password Setting
This screen allows you to set a password for your Switch.
Password Protection. To set a password for your network, select Enable from the drop-down menu. Enter your
user name in the field, then the password. Enter the password again to confirm that it is correct. If you don't want
to have a password to configure the Switch, select Disable.
Chapter 5: Configuring the Switch through the Web Utility
System Tab

Figure 5-6: System Tab-Username/Password Setting

21