Figure 4-9: Advanced Switch Configuration; Figure 4-10: Password Setting - Linksys SRW224 User Manual

24-port 10/100 + 2-Port Gigabit Switch with WebView
Advanced Switch Configuration
This screen allows you to make advanced switch configuration settings.
Broadcast Storm Filter. This allows you to filter by percentage the amount of broadcast traffic to your network to
prevent a storm of too many broadcasts from being sent at the same time. Select 5%, 10%, or 20%. Select Off to
prevent filtering.
Collision Retry Forever. In a collision, a packet will be re-sent until it reaches its destination. To enable this
feature, select Enable. To disable this feature, select Disable.
MAC Table Auto-Aging. If there is no response froma network device when searching for a MAC address within
the chosen time, the switch will remove the MAC address from the MAC address table. Select 150 sec, 300 sec, or

Figure 4-9: Advanced Switch Configuration

600 sec. To disable this feature, select Disable.
MAC Table Hashing. Select from a choice of two algorithm types used to check the MAC address table to
determine which MAC address is associated with what port or destination on the network. Select Direct Map or
CRC (Cyclical Redundancy Checking) Hash.
Console Auto Logout Time. The console will log out after the chosen time. Select 5 min, 10 min, or 20 min. Select
Never to disable the feature.
Web Auto Logout Time. The Web interface will log out after the chosen time. Select 5 min, 10 min, or 20 min.
Password Configuration
This screen allows you to set a password for your Switch.
Password Protection. To set a password for your network, select Enable. Enter your user name in the field, then
the password. Enter the password again to confirm that it is correct. If you don't want to have a password to enter
the network, select Disable. The Username and Password can only be a maximum of six characters, using the
letters a through z, and numbers 0 through 9.

Figure 4-10: Password Setting

Chapter 4: Configuration using the Console Interface 14
Configuring the Switch through the Console Interface