Installing The Ink Cartridges; Filling With Ink For The First Time - Roland VersaCamm VS-640i Setup Manual

5. Installing the Ink Cartridges

Filling with Ink for the First Time

Special procedures are required when installing ink cartridges for the first time. These are required only once,
when installing ink cartridges for the first time after shipment from the factory. Firstly, clean the print heads
with the cleaning cartridges, and then fill with the inks of each color. This operation requires two SOL INK
cleaning cartridges and six dummy cartridges.
*For SOL INK cleaning cartridges and ink cartridges, be sure to use new ones.
*Never, under any circumstances, use anything other than the specified type of ink or cleaning liquid.
CAUTION
1.
Switch on the power and make the initial settings.


w
30
Never insert your hand or fingers into the opening of the front cover.
The print heads move at high speed inside the cover. Hitting may cause injury.
Close the front cover.
Switch on the main power switch.
Hold down and press the sub power
switch.