The Status Tab - Router; Figure 5-50: Administration Tab - Reboot; Figure 5-51: Status Tab - Router - Linksys WRH54G User Manual

Wireless-G Home Router
The Administration Tab - Reboot
The Reboot screen is used to reboot the Router.
To reboot the Router, select Yes for Reboot the Device, then click the Save Settings button. All of your settings
will reset to the default settings.

Figure 5-50: Administration Tab - Reboot

The Status Tab - Router

The Router screen on the Status Tab displays the Router's current status.
Firmware Version. This is the Router's current firmware.
Current Time. This shows the time, as you set on the Setup Tab.
MAC Address. This is the Router's MAC Address, as seen by your ISP.
Router Name. This is the specific name for the Router, which you set on the Setup Tab.
Host Name. If required by your ISP, this would have been entered on the Setup Tab.
Domain Name. If required by your ISP, this would have been entered on the Setup Tab.
Configuration Type. This shows the information required by your ISP for connection to the Internet. This
information was entered on the Setup Tab. You can Connect or Disconnect your connection here by clicking on
that button.
When you finish making changes to this screen, click the Save Settings button to save the changes, or click the
Cancel Changes button to undo your changes. Help information is shown on the right-hand side of the screen.
For additional help, click More.

Figure 5-51: Status Tab - Router

Chapter 5: Configuring the Wireless-G Home Router 42
The Status Tab - Router