Travis Industries DVL Insert EF II Owner's Manual page 42

42
Optional Equipment
4 Attach the rheostat assembly and wiring harness as shown below.
NOTE: Make sure the
grounding wire remains
attached (if applicable).
Use the included wire nut to connect
the wire leading from the rheostat to
the remaining wire leading from the
accent light.
Slide the rheostat assembly into
place and secure with the
included nuts.
5 Restore the firebox to the correct configuration (replace the burners, etc.).
Accent Light Operation
NOTE: The accent light responds
best when turned to high, then
turned down to the desired light
level.
© Travis Industries
d
b
e
Attach the two molex connectors on the
rheostat wiring harness to the power cord and
the molex connector on the appliance.
Make sure all wiring does not contact the
firebox or blower (use wireties if necessary).
(for qualified installers only)
Disconnect the molex connector
a
leading to the power cord.
OFF LOW
Turn the dial all the Turn the dial 180°
way counter-clockwise clockwise until the light
until it clicks off. begins to glow.
4080123
c
Attach the quick-
connect from the
accent light to the
quick-connect on the
rheostat wiring
harness.
HIGH
The high position
is all the way
clockwise.
100-01174_002