Twisted-Pair Cabling - Linksys EtherFast Instant Broadband BEFW11S4 User Manual

Instant broadband series wireless access point + cable/dsl router with 4-port switch
Hide thumbs Also See for EtherFast Instant Broadband BEFW11S4:
Table of Contents

Advertisement

6. Find and double-click TCP/IP in the list to the right (below).
7. After a few seconds you will be brought back to the main Network win-
dow. The TCP/IP Protocol should now be listed.
8. Click OK. Windows may ask for original Windows installation files.
Supply them as needed (i.e.: D:\win98, D:\win95,
c:\windows\options\cabs.)
9. Windows will ask you to restart the PC. Click Yes.
The TCP/IP Installation is complete.
49
Instant Broadband
TM
Series
EtherFast
®
Wireless Access Point + Cable/DSL Router with 4-Port Switch

Twisted-Pair Cabling

There are different grades, or categories, of twisted-pair cabling. Category 5
is the most reliable and is highly recommended. Category 3 is a good second
choice. Straight-through cables are used for connecting computers to a hub.
Crossover cables are used for connecting a hub to another hub (there is an
exception: some hubs have a built-in uplink port that is crossed internally,
which allows you to link or connect hubs together with a straight-through
detailed information on
straight-through and
crossover cabling.
To determine which wire is wire number 1, hold the cable
so that the end of the plastic RJ-45 tip (the part that goes
into a wall jack first) is facing away from you. Face the clip
down so that the copper side faces up (the springy clip will
now be parallel to the floor).When looking down on the
copper side, wire 1 will be on the far left.
cable instead).
You can buy pre-made Category 5
cabling, or cut and crimp your own.
Category 5 cables can be purchased
or crimped as either straight-through
or crossover. Inside a Category 5
cable are 8 thin, color-coded wires
inside that run from one end of the
cable to the other. All 8 wires are
used. In a straight-through cable,
wires 1, 2, 3, and 6 at one end of the
cable are also wires 1, 2, 3, and 6 at
the other end. In a crossover cable,
the order of the wires change from
one end to the other: wire 1 becomes
3, and 2 becomes 6.
See the diagrams on the
next page for more
50

Advertisement

Table of Contents
loading

This manual is also suitable for:

Befw11s4-rm - wireless-b broadband router

Table of Contents