Linksys EtherFast Instant Broadband BEFW11S4 User Manual page 11

PPPoE (Point-to-Point Protocol over Ethernet) Some DSL-based ISPs
use PPPoE to establish communications with an end-user. If you are
using a DSL line, check with your ISP to see if they use PPPoE. If they
do use PPPoE, you must enable it. If you do enable PPPoE, remember to
remove any existing PPPoE applications already on any of your PCs. To
enable PPPoE:
1. Click on the Enable option in the PPPoE section of the Setup screen.
2. Enter the User Name you use to log on to your Internet connection.
3. Enter your corresponding Password.
N N o o t t e e : : RAS Settings are for Singapore customers only. If you are a Singapore
customer, contact your ISP for RAS Settings before trying to complete this
screen.
Connect on Demand (Only available if PPPoE is enabled) If you aren't
actively using the Internet, you can configure your Router to cut your con-
nection with your ISP after a certain period of time. If you have been dis-
connected due to inactivity, Connect on Demand enables your Router to
automatically re-establish your connection as soon as you attempt to
access the Internet again. If you wish to activate Connect on Demand,
choose the Enable option.
Max Idle Time (Only available if PPPoE is enabled) Max Idle Time is the
number of minutes that passes before the Router drops your Internet con-
nection, due to inactivity. For best connection reliability, the recommended
settings are 0 or 9999. Otherwise, enter in the number of minutes you
want to elapse before your Internet access disconnects.
Keep Alive Option (Only available if PPPoE is enabled) This option keeps
your PPPoE-enabled Internet access connected indefinitely, even when it
sits idle. It keeps the connection alive by sending out a few data packets
periodically, so your Internet service thinks that the connection is still
active. To use this option, click on the box next to Keep Alive to select it.
5. When you have properly configured the Setup page, click Apply, then
click Continue.
15
Instant Broadband TM Series
EtherFast ® Wireless Access Point + Cable/DSL Router with 4-Port Switch
6. Choose the DHCP tab.
N N o o t t e e : : You cannot have two DHCP servers running on one LAN at the same time. If
you have an existing DHCP server on your LAN, you must decide which device will
act as server. If you choose this Router, you must disable the DHCP capabilities of the
other device, and vice versa. The device which is not the DHCP server must have a
static IP address, which must be compatible with your existing network in order to be
recognized.
7. Unless you already have a DHCP server on your internal network,
choose Enable from the DHCP Server field. By choosing Enable, you will
configure the Router to automatically assign IP addresses to each of your
PCs. In the Number of DHCP Users box, enter the number of PCs you plan
on networking to the Router. Don't forget to change this number if, in the
future, you add more PCs to your network. In most cases, these values will
not have to be changed unless you have more than 50 computers on the
network.
8. Click Apply, then click Continue.
9. Reset the power on the cable or DSL modem,
then restart the computer so the computer can
obtain the new Router information.
Your Wireless Access Point + Cable/DSL Router is now configured to
your network. If you would like, you may continue on to learn more
about the Router's Web-based Utility.
N N o o t t e e : : Make sure that a
Network Card or
adapter has been suc-
cessfully installed into
each PC you plan on
configuring prior to
continuing.
16