Linksys EtherFast Instant Broadband BEFW11S4 User Manual page 10

2. A username and password prompt will appear. Leave the User Name
box empty and type admin (the default password) in the Password box.
Click OK.
3. The Wireless AP + Cable/DSL Router's Setup page will appear.
13
Instant Broadband TM Series
N N o o t t e e : : Due to dif-
ferences in web
browsers, some
of the screens
shown may differ
from those seen
on your router.
EtherFast ® Wireless Access Point + Cable/DSL Router with 4-Port Switch
4. Configure the following values.
N N o o t t e e : : All of this information should be readily available from your ISP.
Host Name & Domain Name These fields allow you to supply a host and
domain name for the Router. Some ISPs require these names as identifi-
cation. You may have to check with your ISP to see if your Broadband
Internet service has been configured with a host and domain name. In
most cases, leaving these fields blank will work.
LAN IP Address These values refer to your internal network settings.
Unless you have specific internal needs, there should be no reason to
change these values. For the internal LAN, the default values are as fol-
lows.
• Private IP Address:
• Subnet Mask:
Wireless In this section, you can decide whether or not to use WEP
Encryption and configure the level of WEP Encryption. WEP
Encryption is not necessary for the operation of your Router. For more
information, see the section of this guide called Setting WEP
Encryption.
WAN IP Address These values refer to the outside network you connect to
every time you access your Broadband Internet connection. Most
Broadband ISPs assign their clients with a different IP address each time
they log on. If this is the case with your ISP, click Obtain an IP
Address Automatically and continue to step 5. If your ISP assigns you a
fixed IP address, click Specify an IP Address and enter the address into
the Subnet Mask, Default Gateway Address and DNS fields provided
by the ISP.
192.168.1.1
255.255.255.0
14