Table of Contents
Advertisement
Chapter 3
WEP (Wired Equivalent Privacy)
If the network uses WEP encryption, then the WEP Key
or Passphrase Needed for Connection screen appears.
WEP Security
Passphrase
Enter the Passphrase or WEP key.
The passphrase is case-sensitive and must be 16 or
fewer alphanumeric characters. It must match the
passphrase of your other wireless network devices
and is compatible with Linksys wireless products only.
(For non-Linksys wireless products, enter the WEP key
manually.)
If you enter the network's WEP key, enter the
appropriate number of hexadecimal characters ("0" to
"9" and "A" to "F"). For 64-bit encryption, enter exactly
10 hexadecimal characters. For 128 -bit encryption,
enter exactly 26 hexadecimal characters.
To connect to the network, click Connect. To cancel
the connection, click Cancel.
2.
Click
Finish.
Congratulations
Congratulations! The profile is
successfully configured.
Dual-Band Wireless-N USB Network Adapter
Advanced Configuration
Advanced Setup
If your network is not listed with the available networks,
use Advanced Setup.
Available Wireless Networks
1.
Click
Advanced Setup on the Available Wireless
Networks screen to set up the Adapter manually.
2.
The
Network Settings screen appears.
Wireless Network
If your network has a router or other DHCP server, select
Obtain network settings automatically (DHCP).
If your network does not have a DHCP server or router,
select Specify network settings. Enter an IP Address,
Subnet Mask, Default Gateway, and DNS addresses
appropriate for your network. You must specify the
IP Address and Subnet Mask on this screen. If you are
unsure about the Default Gateway and DNS addresses,
leave these fields blank.
IP Address
This IP Address must be unique to
–
your network.
Subnet Mask
The Adapter's Subnet Mask must be
–
the same as your wired network's Subnet Mask.
18
Advertisement
Table of Contents
