(B)
• [Yellow, Magenta, Cyan Left/Right/Horizontal] display
• YES
• NO
• NO
• NO
• YES
• NO
• NO
• NO
• NO
• YES
1. When replacing the Engine PCB (S2V PWB), remove the EEPROM from the old PCB,
Note
then mount that EEPROM on the new PCB.
2. If the EEPROM is not going to be replaced, refer to Section 5.2.2.
Rev. 1
Replace the belt unit. Has operation been restored?
YES
END
Replace the ID unit. Has operation been restored?
YES
END
Is the gear abnormal? (I/D, Multipurpose Tray, Belt Unit, Belt Motor, etc. gear
Assy)
YES
Replace the damaged gear Assy.
LED head Unit PCB (S2H PWB) connection properly connected?
NO
LED head Unit PCB connection Connect properly.
Check the cable connection, then replace the LED head Assy. Has operation
been restored?
YES
END
Check the cable connection, Replace the PCB (S2H PWB) connection. Has
operation been restored?
YES
END
Is the Engine PCB (S2V PWB) properly connected to the PCB (S2H PWB)?
NO
Properly connect the engine PCB to the PCB connection.
Replace the engine PCB. Has operation been restored?
YES
END
Is the I/D unit terminal properly connected to the contact Assy?
(Refer to Figure 7-3)
NO
Properly connect the I/D unit terminal to the contact Assy.
Replace Image Drum Unit.
157 /