Rx Frequency (For Only Rx Channels); Rx Channel Setting - Icom ic-450 Instruction Manual

■ RX frequency
The RX channel frequency can be set to between 450 and
520 MHz.
D RX channel setting
The RX channels are set to "Disable," and they are not
displayed on the screen as the default setting. The RX
channels need be set to "Enable" in order to set the RX
frequency.
While holding down and
q
ON the transceiver power.
• The RX channel list screen is displayed as shown below.
w Push [] or [] to select the desired RX channel, and
then select "Enable."
Hold down to turn OFF the transceiver power, and
e
then turn ON again for the operating mode.
(for RX only channels)
, hold down to turn
D RX frequency setting
Push [] or [] to select the desired RX channel.
q
Push to enter the menu mode.
w
Push [ ] or [] to select "RX VFO" to enter the RX
e
frequency editing mode.
Push [] or [] to select the digit to edit, and then push
r
[] or [] to change the selected digit.
• You can enter between 450 and 520 MHz. (12.5 kHz steps)
Repeat step r to enter the desired frequency.
t
Push [] to set the RX frequency.
y
• Two beeps sound.
Push several times to return to the operating mode.
u
OTHER FUNCTIONS
9
9
33