Wheel Puncture/Tyre Pressure; Battery - Bajaj Pulsar 150 CC DTS-i User Manual

General Maintenance Information
Wheel Puncture :
Use recommended levers
while removing the Tyre / Tube for puncture
work. This will avoid any damages to the
edges / scratches on paint of the wheel.
Tyre Pressure :
Keep appropriate tyre
pressure as mentioned below to increase life
of the tyre & for better fuel consumption.
Front 1.75 Kg/Cm (25.0 psi) 2
Rear (Solo) 2.00 Kg/Cm (28.5 psi) 2
2
Rear (with Pillion) 2.25 Kg/Cm (32.0 psi)
Drive Chain Slackness
• Chain top edge to be kept between the two
marks during chain slackness adjustment.
• Care should be taken, that the chain should
never run dry.
• Lubricate chain from outside with SAE 90 oil
at every 500 kms.
• Chain slackness will have to be adjusted
whenever required.
17
General Maintenance Information
Battery : 12V - 9 Ah, MF
• Battery is located inside 'Side Cover' LH.
• Always ensure that battery electrolyte level
is in between max & min level marks.
• Check & top up battery by distilled water if
electrolyte level is below min level mark.
• Battery life would get adversely affected if
top up with 'Tap Water'.
• Environment care must be taken to dispose
off used battery. It is always recommended
to hand over the same to the Authorised
battery / Bajaj dealer for proper disposal.
• When battery is found discharged, it is
advised to get it charged immediately.
CAUTION : Do not drive/run vehicle in
battery disconnected condition. It may
lead to damage of electrical / electronic
components.
Spark Plug
• Remove spark plugs by using plug spanner.
• Clean the spark plugs.
• Adjust the gaps if incorrect by bending
outer electrode carefully.
Spark Plug Gap : 0.6 to 0.8 mm.
Spark Plug (2 Nos) : CHAMPION RG 4 HC
18