GE JBP19 Use And Care & Installation Manual page 34

STEP8
ANTI-TIP BRACKETIHSTWWTION
N
~TI-~P bracket is suppfiedwith instructions
for installationin a varietyof locations.The
instructions includea template,a parts fist and a
list of tools necessary to completethe installation.
Read the IMPORT~T S~~ INSTRU~ONS
and the instructions that fityour situationbefore
beginning installation.
WARNING
1.
Range must be secured by NTI-~P bracket
suppfied.
2. See instructions to install (suppfiedwith
bracket).
3. Unless properly installed, range could be
tipped by stepping or sitting on door. Injury
might result from spilled hot tiquids or from
range itseti.
Typical Installationof Anti-TipBracket
Attachmentto Wall
Bracket
ScrewMust Enter
STEP9
LEVELINGTHE RANGE
The
range must be level. bveling feet are located
at each corner of the base of the range. Remove
the storage drawer or kick panel (depending on
your model) and using channel locks, rohte the
leveting feet in and out as required to level the
range. @or instructions on how to remove and
replace the storage drawer or the kick panel, see
the Cleaning Under the Range section in Care
and Cleaning.) On some models, there are plastic
covers which may be removed for easy
adjustment oust squeeze and pull).
One of the rear levefingfeet will engage the
~~-TIP bracket (allowfor some side to side
adjustment). Nlow a minimum clearance of 1/8
between the range and the levefingfoot that is to
be instilled into the NTI-TIP bracket.
Check the range for proper installation into the
N~-TIP bracket (after the range has been
properly instilled) by removing the kick panel or
storage drawer and inspecting the rear leveling
leg. Make sure it fits securely into the slot.
STEP10
FINAL CHECK
Be sure all switches are in the OFF position
before leaving the range.
34