Nom_Delay_N; Rtp_Port_Min; Rtp_Port_Max - Panasonic KX-UT123 Administrator's Manual

NOM_DELAY_n

Parameter Name Example
Value Format
Description
Value Range
Default Value
Web User Interface Reference

RTP_PORT_MIN

Value Format
Description
Value Range
Default Value
Web User Interface Reference

RTP_PORT_MAX

Value Format
Document Version 2013-03
NOM_DELAY_1, NOM_DELAY_2, ..., NOM_DELAY_6
Integer
Specifies the initial delay, in 10-millisecond units, of the jitter buffer.
1–7 (´ 10 ms)
Note
•
This setting is subject to the following conditions:
–
This value must be greater than or equal to "MIN_DELAY"
–
This value must be less than "MAX_DELAY"
2
Initial Delay (Page 119)
Integer
Specifies the lowest port number that the unit will use for RTP packets.
Note
•
If port numbers are specified in [Channel 1–25] in
4.3.6.3 External RTP Port in the Web user interface, this
setting is ignored and the corresponding external RTP port is
enabled.
1024–48750 (even number only)
Note
•
The value for this setting must be less than or equal to
"RTP_PORT_MAX" - 400.
•
Changing this setting may affect the number of simultaneous
calls that can be made. Therefore, when setting this parameter,
be aware that the maximum number of necessary ports can be
calculated as shown below:
No. of lines ´ No. of channels ´ 2 ´ 10 (No. of terminals)
16000
Minimum RTP Port Number (Page 115)
Integer
5.6.2 RTP Settings
Administrator Guide 237