Dodge DART User Manual page 44

ELECTRONICS
Making A Phone Call
• Press the "Phone" button
• (After the BEEP), say "dial" (or "call" a name).
Receiving A Call – Accept (And End)
• When an incoming call rings/is announced on Uconnect®, press the Phone button
• To end a call, press the Phone button
Mute (Or Unmute) Microphone During Call
• During a call, press the "Voice Command" button
• (After the BEEP), say "mute" (or "mute off").
Transfer Ongoing Call Between Handset And Vehicle
• During a call, press the "Voice Command" button
• (After the BEEP), say "transfer call".
Changing The Volume
• Start a dialogue by pressing the "Phone" button
normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level
while the Uconnect® system is speaking. Please note the volume setting for Uconnect® is
different than the audio system.
Uconnect® Voice Command
• The Uconnect® Voice Command system allows you to control your AM, FM radio, satellite
radio, disc player, Uconnect® Phone and supported portable media devices.
• When you press the "Voice Command" button
will hear a beep. The beep is your signal to give a command. If you do not say a command
within a few seconds, the system will present you with a list of options. If you ever wish to
interrupt the system while it lists options, press the "Voice Command" button
listen for the BEEP, and say your command.
Voice Command Operation
• Start a dialogue by pressing the "Voice Command" button , you will hear a beep. The beep
is your signal to give a command. Below are a list of voice commands for each of the
different modes.
42
.
.
.
.
, then adjust the volume during a
located on the steering wheel, you
.
,