Port Config - TP-Link TL-SG2424 User Manual

Fast Start Times:

13.1.2 Port Config

On this page you can configure all ports' LLDP parameters.
Choose the menu LLDP→Basic Config→Port Config to load the following page.
The following entries are displayed on this screen:
LLDP Port Config

Port Select:
Admin Status:
Notification Mode:
Included TLVs:
When the port's LLDP state transforms from Disable (or Rx_Only)
to Tx&Rx (or Tx_Only), the fast start mechanism will be enabled,
that is, the transmit interval will be shorten to a second, and
several LLDPDUs will be sent out (the number of LLDPDUs
equals this parameter). The default value is 3.
Figure 13-2 LLDP Port Config
Select the desired port to configure.
Select the port's LLDP operating mode:
Tx&Rx: send and receive LLDP frames.
Rx_Only: Only receive LLDP frames.
Tx_Only: Only send LLDP frames.
Disable: neither send nor receive LLDP frames.
Allows you to enable or disable the ports' SNMP notification. If
enabled, the local device will notify the trap event to SNMP server.
Select TLVs to be included in outgoing LLDPDU.
Click the Detail button to display the included TLVs and select the
desired TLVs.
173