TP-Link TL-SG2424 User Manual page 12

Chapter
Chapter 9 QoS
Chapter 10 ACL
Chapter 11 PoE
Chapter 12 SNMP
Chapter 13 LLDP
Introduction
This module is used to configure QoS function to provide
different quality of service for various network applications and
requirements. Here mainly introduces:
DiffServ: Configure priorities, port priority, 802.1P priority and

DSCP priority.
Bandwidth Control: Configure rate limit feature to control the

traffic rate on each port; configure storm control feature to
filter broadcast, multicast and UL frame in the network.
Voice VLAN: Configure voice VLAN to transmit voice data

stream within the specified VLAN so as to ensure the
transmission priority of voice data stream and voice quality.
This module is used to configure match rules and process
policies of packets to filter packets in order to control the access
of the illegal users to the network. Here mainly introduces:
ACL Config: ACL rules.

Policy Config: Configure operation policies.

Policy Binding: Bind the policy to a port/VLAN to take its

effect on a specific port/VLAN.
This module is used to configure the PoE function for the switch
to supply power for PD devices. Here mainly introduces:
PoE Config: Configure PoE function globally.

PoE Time-Range: Configure the effective time for PoE port to

supply power..
This module is used to configure SNMP function to provide a
management frame to monitor and maintain the network
devices. Here mainly introduces:
SNMP Config: Configure global settings of SNMP function.

Notification: Configure

management station to monitor and process the events.
RMON: Configure RMON function to monitor network more

efficiently.
This module is used to configure LLDP function to provide
information for SNMP applications to simplify troubleshooting.
Here mainly introduces:
Basic Config: Configure the LLDP parameters of the device.

Device Info: View the LLDP information of the local device

and its neighbors
Device Statistics: View the LLDP statistics of the local device

LLDP-MED: Configure LLDP-MED parameters of the device.

4
notification function for the