Table of Contents
Advertisement
5. Plug the telephone cord into the wall jack. Hook both
sides of the telephone cord into the larger notch OR tuck
the excess cord into the open space in the bracket.
6. Place the mounting slots over the
pins on the wall plate.
7. Slide the base down to lock it
into place.
8. Removing the wall-mount bracket: At the bottom of the
base, lift up on the release latch between the two bottom
tabs and push the bracket up.
Before doing this, consider the following:
#
Mounting the phone directly on the wall
Avoid electrical cables, pipes, or other items behind the mounting
location that could cause a hazard when inserting screws into the
wall.
Mount your phone within distance of a working phone jack.
Make sure the wall material is capable of supporting the weight of
the base and handset.
Use screws with anchoring devices suitable for the wall material
where the base unit will be placed.
Be sure the wall is capable of supporting the weight of the phone,
and use the proper type of anchoring device for the wall material.
Insert two #10 screws (minimum length of 35mm, not supplied)
into the wall, 100mm apart.
Leave the screw heads 3mm away from the wall to allow room for
mounting the phone.
Align the mounting slots over the screws and slide the base down
into place as shown above.
Wall plate
(To AC outlet)
25
Advertisement
Table of Contents
