Table of Contents
Advertisement
Comtech EF Data Documentation Update
Subject:
Date:
Errata Numbers:
Agile Document IDs
Change Specifics:
This information will be incorporated into the next revisions.
MN-CMR5995-IOM, Rev1, Section 4.3.11, Tuner Menu
MN-CMR6000-IOM, Rev1, Section 4.4.11, Tuner Menu
Change From:
Fill Rate:
Note: It is recommended that this value NOT be changed.
Change To:
Fill Rate:
This value should not be changed from the factory default setting (1,000,000) unless the receiver
is being utilized for low-latency traffic such as VoIP traffic. Comtech EF Data recommends
modifying this parameter to improve latency and jitter performance, to a setting greater than
5,000,000. The actual setting will depend upon traffic and may need to be set on a per case
basis. The valid value range is 0 to 10,000,000, with the default as 1,000,000. VoIP traffic may
require a setting between 5,000,000 to 10,000,000. Setting the Fill Rate to 10,000,000 (the
maximum setting) may lower the overall performance (packets per second and bits per second)
of the product by as much as 10%, so care must be taken when modifying this parameter.
AGILE DOC IDs: ER-CMR5995-EA1, ER-CMR6000-EA1
THIS DOCUMENT IS NOT SUBJECT TO REVISION
Errata A
Changes to:
MN-CMR5995-IOM, Rev1, Section 4.3.11, Tuner Menu
MN-CMR6000-IOM, Rev1, Section 4.4.11, Tuner Menu
October 8, 2008
ER-CMR5995-EA1
ER-CMR6000-EA1
ER-CMR5995-EA1
ER-CMR6000-EA1
Agile CO Number
CO5247
AGILE C05247
Page 1
Advertisement
Table of Contents
