Table of Contents
Advertisement
Digicast Media Router S2 Receiver CMR-5995 (MR-S2-ASI)
Installation & Initial Configuration
2.4
Initial Configuration
The initial configuration requires setting up the IP parameters using the terminal cable.
Once the IP parameters have been configured, the terminal cable can be removed. Store
the terminal cable in a known location, because it may be needed in the future.
To configure the IP parameters:
Step
Procedure
1
Using a terminal emulator on a PC such as HyperTerminal™ or TeraTerm™, set up the
communication port as follows:
38,400 BAUD
8 Data Bits
1 Stop Bit
No Parity
No Flow Control
2
Press the <ENTER> key on the PC – the login prompt should be displayed.
3
The default user is "comtech" and the default password is "comtech". After logging in, the
CMR-5995's menu should be displayed.
4
Press "N" for Network Menu.
5
Press "I" for the IP Address, Enter the IP Address and press <ENTER>.
6
Press "M" for the Subnet Mask. Enter the Subnet Mask and press <ENTER>.
7
Press "G" for the Default Gateway IP Address. Enter the Default Gateway Address and
press <ENTER>.
8
Press "S" to save the parameters.
9
Press "Y" to confirm the saving of parameters.
10
Press "X" to exit to the main menu.
After completing Step 10, the unit has been configured for full IP operation and the
terminal cable may be removed. (For continued operation, the unit may be managed via
the Terminal Interface; however, it is recommended to use the Web Interface for ease of
management.)
Additional configuration and management is best performed using the Web interface
(refer to
Chapter 4, Device Management Via User
Once fully configured, the coaxial connection to the Low Noise Block (LNB) may be
safely attached to the L-Band input port. Read Section 2.5, Connect External Cables, for
more information about the LNB connection.
Interfaces).
2-3
Revision 1
MN-CMR5995-IOM
Advertisement
Table of Contents
