Resetting User Port Keyboards And Mice - Lindy 32351 Manual

However it is sometimes useful to be able to connect to ports on cascaded units via
a specific cascade cable (rather than the first available of a group) in order to check
that the cabling is working as expected. To do this you can use a hotkey sequence
similar to the example shown below.
For example to connect to port 14 on a LINDY CPU Switch Dual Junior that is
cascaded off port 1 of your first LINDY CPU Switch Dual Junior. Although the
following example selects a port with a four digit address (port 0114) you can type
port addresses that are eight digits long to access computers that are on the forth
cascade level (e.g. Port 01140203).
ba ba 0
press
press

4.16 Resetting user port keyboards and mice

The LINDY CPU Switch gives you the facility to perform a complete power off reset
of the keyboard and mouse that are connected to a selected user port. This can be
useful if you wish to disconnect the keyboard or mouse and replace them with
alternatives. Keyboards will enable themselves automatically if they are
disconnected and then re-connected to the LINDY CPU Switch. Mice will not
normally re-enable themselves after they have been disconnected and re-connected
although they will do so automatically if the LINDY CPU Switch's channel has been
changed whilst the mouse is disconnected.
Consequently you will normally need to perform a power-off reset of the user port if
you have disconnected and re-connected a mouse. The power off reset function
only affects the selected user port and does not affect any of the computer
connections or any of the other user ports. To perform a power-off reset for a
selected user port:
1) Press the USER key on the front panel of the LINDY CPU Switch to select the
LINDY CPU Switch Dual Junior Installation and Use
0
release
1 1 1 1
release
1 1
press release
4 4
press
0 0
1 1
4 ba ba
4
release
Page 54