White Mountain Hearth DVTL27FP90N-1 Installation Instructions And Owner's Manual page 59

Accessing Gas Valve and Controls
1. Remove the Offset Frame and Glass Frame.
2. Remove the Burner Components Heat Shield. See Figure 86.
3. Remove logs from firebox.
4. Remove the liner bracket on top of the right-hand liner panel
and remove right hand liner panel.
5. Remove the Access Plate. See Figure 86.
NOTE: The control Module is located in the front right hand corner
of the cavity. To remove it, lift up and away from the wall.
NOTE: If it is necessary to remove one of the gas valve train
components, break free the plumbing fittings and remove
the screw indicated in Figure 87.
33740-7-0515
MAINTENANCE AND SERVICE
ACCESS
PLATE
BURNER
COMPONENTS
HEAT SHIELD
Figure 86
Figure 87
Page 59