White Mountain Hearth DVTL27FP90N-1 Installation Instructions And Owner's Manual page 49

MULTIFUNCTION REMOTE OpERATING INSTRUCTIONS
Continuous pilot/Intermittent pilot (CpI/IpI) Selection
With the system in "OFF" position press the Mode Button (Figure
56) to index to the CPI mode icon. See Figures 79 and 80.
Pressing the Up Arrow Button will activate the CPI. Pressing the
Down Arrow Button will return to IPI. A single "beep" will confirm
the reception of the command.
OFF
OFF
33740-7-0515
Figure 79
Figure 80
Button Lock
This function will lock the Buttons to avoid unsupervised opera-
tion.
To activate this function, press the MODE and UP Buttons at the
same time. See Figure 81.
To deactivate this function, press the MODE and UP Buttons at
the same time.
OFF
Low Battery power Detection - Transmitter
The life span of the remote control batteries depends on various
factors: quality of the batteries used, the number of ignitions of
the appliance, the number of changes to the room thermostat set
point, etc.
When the transmitter batteries are low, an Icon will appear on the
LCD display of the transmitter See Figure 82 before all battery
power is lost. When the batteries are replaced this Icon will disap-
pear.
OFF
Figure 81
Figure 82
Page 49