White Mountain Hearth DVTL27FP90N-1 Installation Instructions And Owner's Manual page 32

Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling
logs, wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation of this appliance. Sooting and other problems may result
if the logs are not properly and firmly positioned in the appliance.
Refer to Figures 52 & 53 for the following warning.
Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
B
C
Log placement Figure 52
FRONT VIEW - COMpLETED LOG SET INSTALLATION (WITHOUT EMBERS) Figure 53
Page 32
LOG pLACEMENT
G
A
F
D
E
WARNING
Attention: Do not use Figure 52 to order replacement logs.
Refer to Page 31, Parts List and Parts View to order logs
for your appropriate model number
NOTE: Once the installation is complete with the glowing
embers and log set in place, operate the fireplace to verify
flame appearance. If there are flames directly impinging
a log, turn off fireplace, then remove the glowing ember
material directly below where the flame impingement
occurred. This should eliminate sooting on the log, and
provide a more pleasing flame appearance.
Replacement of glowing embers must be purchased
from Empire Comfort Systems, Inc. Application of excess
glowing embers may adversely affect performance of the
appliance.
All previously applied loose material must be removed
prior to reapplication.
WARNING
33740-7-0515