Minimum Framing Dimensions - Napoleon GD36NTR Installation And Operating Instructions Manual

Minimum clearance to combustible construction from appliance and vent surfaces:
Combustible Framing:
-
-
-
Combustible Finishing:
-
-
-
Rear Exit
-
-
Top Exit
-
-
* BGD36 HORIZONTAL VENT SECTIONS: A minimum of 1" at the bottom and sides and 2" at the top of the
vent pipe on all horizontal runs to combustibles is required. Use fi restop spacer W010-1774 (supplied).
* BGD36 VERTICAL VENT SECTIONS: A minimum of 1" all around the vent pipe on all vertical runs to com-
bustibles is required except for clearances in appliance enclosures. See "MINIMUM ENCLOSURE CLEAR-
ANCES" section. Use fi restop spacer W500-0096 (not supplied).

5.2.1 MINIMUM FRAMING DIMENSIONS

FOR TOP EXIT APPLICATIONS: DO NOT BUILD INTO THIS AREA. IT MUST BE LEFT CLEAR TO
PROVIDE ADEQUATE CLEARANCE FOR THE VENT. IN THIS 14" WIDE AREA CENTRED ALONG THE
TOP EXIT INSTALLATION
SHOWN
ENCLOSURE
63"
(TOP EXIT)
42 1 /4"
(REAR EXIT)
14 1 /2"
Combustion protrusions such as mantels and shelves may
occur at or after a minimum distance of 2" away from the side
of the appliance. Thereafter, the depth of any protrusions must
be equal to or less than the distance from the side of the appliance up to a depth
of 6", after which no greater clearance than 6" is required. This can be considered
a side wall with no length boundary.
0" to stand-offs
1" to bottom and sides of the vent pipe*
2" to top of the vent pipe*
0" to rear
0" to front face top and sides
14 1/4" recessed depth
39" to enclosure top from base of the appliance
72" to ceiling from base of the appliance
48 3/8" to enclosure top from base of the appliance
72" to ceiling from base of the appliance
FRONT OF THE APPLIANCE, NO COMBUSTIBLES ARE ALLOWED.
TOP
14"
MINIMUM
1 1 /2"
FINISHING
MAX
MATERIAL
GAS
INLET
LOCATION
35 3 /4"
3"
5 1 /2"
36 1 /2"
WARNING
!
3 /4"
36
3 1 /2"
MAX
OUTSIDE
CHASE
14 1
1 /2"
36
/2"
1 /2"
36
PROTRUSION
35
14 1
/2"
INSIDE
CHASE
2"
4"
SIDE
2"
4" WALL
6"
W415-0773 / 06.16.09