Setting The Treble Control; Adjusting The High Pass Filter - Alpine CDA-118M Owner's Manual

Setting the Bass Center Frequency
3
-3 Turn the Rotary encoder to select the desired bass
center frequency, and then press
60 (Hz) 80 (Hz)
Emphasizes the displayed bass frequency ranges.
4
Press to return to normal mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
• If is pressed during setting, the unit returns to the previous item.
• The function is inoperable when DEFEAT is set to ON.
2
* The adjustment can also be made by pressing IMPRINT. Refer to
"Adjusting Subwoofer/Bass/Treble/Balance (Between Left and
Right)/Fader (Between Front and Rear)/Loudness/Defeat" (page 20).

Setting the Treble Control

You can change the Treble Frequency emphasis to create your own tonal
preference.
For this unit, the following setting can be made only when the
IMPRINT audio processor (PXA-H100) is not connected.
1
Press and hold AUDIO for at least 2 seconds to
activate the AUDIO selection mode.
2
Turn the Rotary encoder to select the TREBLE
Adjustment mode, and then press
SUBW SUBW SYSTEM*
HPF SUBW
1
* Displayed only when subwoofer is ON.
Setting the Treble Level
3
2
-1 Turn the Rotary encoder to select the desired
*
treble level (–7~+7), and then press
You can emphasize the treble level.
Setting the Treble Center Frequency
3
-2 Turn the Rotary encoder to select the desired
treble center frequency, and then press
10.0 kHz 12.5 kHz
10.0 kHz
Emphasizes the displayed treble frequency ranges.
4
Press to return to normal mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
• If is pressed during setting, the unit returns to the previous item.
• The function is inoperable when DEFEAT is set to ON.
2
* The adjustment can also be made by pressing IMPRINT. Refer to
"Adjusting Subwoofer/Bass/Treble/Balance (Between Left and
Right)/Fader (Between Front and Rear)/Loudness/Defeat" (page 20).
22
-EN
ENTER.
/
100 (Hz) 120 (Hz) 60 (Hz)
ENTER.
/
1
BASS TREBLE
ENTER.
/
ENTER.
/
15.0 kHz 17.5 kHz

Adjusting the High Pass Filter

The High Pass Filter on this unit can be adjusted to suit your personal
taste.
For this unit, the following setting can be made only when the
IMPRINT audio processor (PXA-H100) is not connected.
1
Press and hold AUDIO for at least 2 seconds to
activate the AUDIO selection mode.
2
Turn the Rotary encoder to select the HPF
Adjustment mode, and then press
SUBW SUBW SYSTEM*
HPF SUBW
1
* Displayed only when subwoofer is ON.
3
Turn the Rotary encoder to select the desired HPF
frequency, and then press
OFF 60 (Hz) 80 (Hz)
4
Press to return to normal mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
• If is pressed during setting, the unit returns to the previous item.
• The function is inoperable when DEFEAT is set to ON.
ENTER.
/
1
BASS TREBLE
ENTER.
/
100 (Hz)