Table of Contents
Advertisement
Setting the Treble Control
You can change the Treble Frequency emphasis to create your own tonal
preference.
1
Press and hold IMPRINT for at least 2 seconds.
The Sound Setup screen is displayed.
2
Rotate the Double Action encoder to select the
"Treble Adjustment", and then press "fENTER.
3
Press "fENTER.
The
Fa setting screen is displayed.
4
Press "fENTER.
5
Rotate the Double Action encoder to select the
desired treble center frequency, and then press
"fENTER.
10 kHz
H
12.5 kHz
H
15 kHz
H
17.5 kHz
Emphasizes the displayed treble frequency ranges.
6
Press and hold .=» for at least 2 seconds to return to
normal mode.
• If'=» is pressed during setting. the unit returns to the previous item.
Thefunction is inoperable when Defeat is set to ON.
• You can adjust the treble level in normal mode. For details, refer to
"Adjusting Subwoofer/Bassrrreblel Balance (Between Left and
Right)/Fader (Between Front and Rear)/Loudness/ Det'eat" (page 18).
• Atier the setting. storing the setting contents on the linit is
recommended. For details, refer to "Storing the Audio Adjustment
Level" (page 23).
Adjusting the High Pass Filter
The High Pass Filter on this unit can be adjusted to suit your personal
taste.
1
Press and hold IMPRINT for at least 2 seconds.
The Sound Setup screen is displayed.
2
Rotate the Double Action encoder to select "High
Pass Filter Adjustment", and then press "fENTER.
3
Rotate the Double Action encoder to select the
desired HPF frequency, and then press "fENTER.
80 Hz
H
120 Hz
H
160 Hz
H
off
4
Press.=» to return to normal mode.
• It''=» is pressed during setting. the IInit returns
to
the previous item.
• The function is inoperable when Det'ellt is set to
ON.
• After setting, storing the setting contents is recommended. For how to
store, refer to "Storing the Audio Adjustment Level" (page 23).
Turning Subwoofer ON/OFF
If an optional subwoofer is connected to the unit. make the following
setting.
When the subwoofer is on. you can adjust the subwoofer output level
(refer to page 18).
1
Press and hold IMPRINT for at least 2 seconds.
The Sound Setup screen is displayed.
2
Rotate the Double Action encoder to select
"Subwoofer", and then press "fENTER.
3
Rotate the Double Action encoder to select
ONfOFF, and then press "fENTER.
4
Press.=» to return to normal mode.
• It''=» is pressed dllring setting. the IInit returns to the previous item.
• You can set the subwoofer Olltput level in normal mOlle. Refer to
"Adjll~·ting
SubwooferiBassrrreblei Balance (Between Left and
Right)/Fader (Between Front lind
Rear)/Lolldnes~/
Det'ear" (page 18).
• You can set the subwooler system in SETUP lIlode. Refer to "Setting
the Subwoofer (Subwo(}ler System)" (page 24).
19-EN
Advertisement
Table of Contents
