Husqvarna Viking Platinum 755 User Manual page 50

Sewing
On your Platinum 715/735, adjust stitch
settings so that the stitch length is 0.0 and
the width is 3.0. Set thread tension to 4 and
presser foot pressure to 6. On your Plati-
num 755, the button stitch is preset for a
button with 3 mm between the holes*.
Sew:
• Place the thin end of the clearance plate
under the button when sewing on light
fabrics. Hold in place with transparent
tape. Use the thick end for heavier fab-
rics.
• Place the button under the ankle with
the holes in the button lined up with the
swing of the needle. Check the swing of
the needle by touching the mirror side
to side button
will not hit the button. Bring the needle
down into the hole of the button with
the hand wheel to verify.
• Zigzag button in place with six to eight
stitches.
• Touch to tie off. Touch
for the next button.
• Raise feed teeth when button sewing is
completed.
* The width of the zigzag is set for most
but tons. If you sew a tiny button or a very
large coat but ton, decrease (-) or increase (+)
the stitch width until the swing of the needle
sews in the holes of the button or snap.
48
to be sure the needle
to repeat