Table of Contents
Advertisement
03 Instruments and controls
Light switches
The headlamp control activates and adjusts
the external lighting. It is also used to adjust
display and instrument lighting and mood
lighting (p. 95).
Overview, light switches
03
Overview, light switches.
Thumbwheel for adjusting display and
instrument lighting as well as ambient
lighting*
Button for rear fog lamp
Knob for daytime running lights and park-
ing lamps
18
Thumbwheel
for headlamp levelling
Not available for cars equipped with active Xenon headlamps*.
18
*
86
Option/accessory, for more information, see Introduction.
Knob positions
NOTE
The same lamps are used for daytime run-
ning lights and position/parking lamps
front. The brightness is higher when the
lamps are used as daytime running lights.
Posi-
Specification
tion
Daytime running lights
the car's electrical system is in
key position II or the engine is
running.
Main beam flash can be used.
Daytime running lights, posi-
tion/parking lamps rear and
side marker lamps when the
car's electrical system is in key
position II or the engine is run-
ning.
Position/parking lamps/side
marker lamps when the car is
parked.
Main beam flash can be used.
Posi-
Specification
tion
Daytime running lights, posi-
tion/parking lamps rear and
side marker lamps in daylight
when the car's electrical sys-
tem is in key position II or the
engine is running.
Dipped beam and position/
parking lamps/side marker
lamps in weak daylight or dark-
A
when
ness, or when the rear fog lamp
or windscreen wipers with con-
tinuous wiping are activated.
The tunnel detection (p. 89)*
function is activated.
The Active main beam (p. 90)*
function can be used.
Main beam can be activated
when dipped beam is switched
on.
Main beam flash can be used.
Dipped beam and position/
parking lamps/side marker
lamps.
Main beam can be activated.
Advertisement
Table of Contents
