Table of Contents
Advertisement
10 Maintenance and service
||
10
Detach the headlamp connector by
pressing down the clip with your thumb.
At the same time, guide out the connec-
tor with your other hand.
5. Lift out the headlamp and place it on a
soft surface to avoid scratching the lens.
6. Replace the bulb in question.
Securing the headlamp
376
1. Plug in the connector, a clicking sound
should be heard.
2. Reinstall the headlamp and locking pins.
The short pin is fitted closest to the grille.
Check that they are firmly inserted.
3. Check the lighting.
The headlamp must be mounted and the con-
nector firmly connected before the lighting is
switched on or the remote control key is
inserted into the ignition switch.
Related information
•
Lamp replacement - general (p. 374)
•
Lamp replacement - cover for main/
dipped beam bulbs (p. 376)
•
Lamps - specifications (p. 381)
Lamp replacement - cover for main/
dipped beam bulbs
Main/dipped beam bulbs are accessed by
releasing the headlamp's larger cover.
Before starting to replace a bulb, see Lamp
replacement - headlamps (p. 375).
1. Unscrew the cover's four screws using a
Torx tool, size T20 (1). They should not be
loosened completely. (3 - 4 turns are suf-
ficient.)
2. Slide the cover to one side.
3. Remove the cover.
Reinstall the cover in reverse order.
Related information
•
Lamp replacement - headlamps (p. 375)
•
Lamp replacement - dipped beam
(p. 377)
Advertisement
Table of Contents
