Appendix A: Advanced Dsl Port Attributes - D-Link DSL-1500G++ User Manual

Appendix A: Advanced DSL port attributes

Attribute
DSP Firmware Version
DSP Version
Connected
Annex Type
State
Mode
Bit Rate Mode
Fixed Bit Rate
Framer sync
Framer Type
Bit Rate
Tx Eoc
Eoc Type
Vender ID
4Wire Enable
4WAuto Start
4WActivate Line
DSL-1500G++ User Manual
DSP code version number
DSL driver version number
Current connected state:
True – modem is connected to a remote modem
False – modem is not connected to a remote modem
Current Annex Type:
1. Annex_A
2. Annex_B
Current state of the device:
Idle – not connected or attempting to connect
HandShake – connecting/hunting for remote modem
Training – connecting/found a remote modem
Showtime – connected to remote modem
To be configured as CO or CPE
The transfer modes provided by the device: Fixed,
adaptive
Nx64(data) + 8xI (data) +8(EOC)
2312kbps = 36*64(data) +8*0(data) + 8 (EOC)
Even though Tx Eoc is set as False, EOC will occupy
8K.
Out_Of_Sync – Framer data unsync
In_Sync - Framer data sync
Framer is a device used to align/synchronize to an
embedded framing pattern in a serial bit stream. Once
synchronized and data fields are properly aligned,
overhead bits for alarms, performance monitoring,
embedded signaling, etc. may be extracted and
processed. Four Framer types are provided: Level2,
Level1A,Level1B.
Transmit and Receive rate (bits per second) of the
device
False: close EOC transmitting and receiving function.
True : Open EOC function (invalid presently)
Six types of Embedded Operations Channel are
selectable, including DIS, INV, STA, CFG, ATMS, and
CFGLB.
It shows the vender ID of the device
Enable – 4Wire mode
Disable – 2Wire mode
"True" - A 4-wire Connection will be established at
power up.
"False" - The modem will remain in Idle mode at power
up.
false – normal operation
true – reset DSP
- 69 -
Value Default
N/A
N/A
False
Annex_A
N/A
CPE
adaptive
2312kbps
Level2
0
False
Disable
False
false