Driving The Tractor And Implement - Alamo Machete 02968915C Operator's Manual

8.DRIVING THE TRACTOR AND IMPLEMENT

Safe tractor transport requires the operator to possess a thorough knowledge of the model being operated
and precautions to take while driving with an attached implement. Ensure the tractor has the capacity to
handle the weight of the boom and the tractor operating controls are set for safe transport. To ensure safety
while driving the tractor with a boom, review the following.
Read all safety instructions. Decals on the Boom warn you of particular and multiple hazards. Some decals
are attached close to part of the Boom where there is a possible hazard.
understand the safety messages before you operate the implement. Keep all decals clean and readable.
Replace lost or damaged decals, refer to safety section for more information.
Power for operating the mower is supplied from the tractor PTO. Refer to your tractor manual instructions for
engaging and disengaging the PTO. Start the tractor and bring the engine speed up to normal operating
speed of 540 PTO RPM. Always engage the PTO at low engine RPM and run the mower for a short period
until all air is removed from the hoses. Keep all person's well clear of mower since blades can throw objects
with great velocity for a considerable distance! KEEP CLEAR! OPS-B- 0005
Never operate the Tractor or Implement until you have read and completely
understand this Manual, the Tractor Operator's Manual, and each of the Safety
Messages found in the Manual or on the Tractor and Implement. Learn how to
stop the tractor engine suddenly in an emergency. Never allow inexperienced
or untrained personnel too operate the Tractor and Implement without
supervision. Make sure the operator has fully read and understood the manuals
prior to operation.
Always maintain the safety decals in good readable condition. If the decals are missing,
damaged, or unreadable, obtain and install replacement decals immediately.
BEFORE leaving the tractor seat, always engage the brake and/or set the
tractor transmission in parking gear, disengage the PTO, stop the engine,
remove the key, and wait for all moving parts to stop. Place the tractor shift
lever into a low range or parking gear to prevent the tractor from rolling. Never
dismount a Tractor that is moving or while the engine is running. Operate the
Tractor controls from the tractor seat only.
MACHETE BOOM 01/05
© 2005 Alamo Group Inc.
OPERATION
(SG-4)
(SG-9)
Operation Section 3-27
Read and make sure you
(SG-5)