Table of Contents
Advertisement
Initial Gateway Configuration
Insert a blank cover panel provided by Cisco.
Step 5
Secure the blank cover panel screws.
Step 6
Caution
Initial Gateway Configuration
Initial monitoring and administration of the gateway are performed from a remote PC via a serial
connection. This allows you to access the boot configuration menu of the gateway. At power-up, the
gateway goes through the following boot phases:
•
•
•
You can perform serial port configuration of the gateway only at startup, during a short period indicated
Note
by a 6-second countdown. Once the initialization phase is complete, the only way you can access the
configuration menu is by restarting the gateway.
Connecting to a PC
This section describes how to use the serial port connection to configure the gateway with an IP address.
Procedure
Locate the terminal cable shipped with the gateway.
Step 1
Connect the end labeled PC to the serial port on the computer.
Step 2
Connect the end labeled Unit to the serial port connector on the gateway front panel.
Step 3
The PC terminal should have an installed terminal emulation application, such as HyperTerminal.
Note
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5
2-10
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference
(EMI) that might disrupt other equipment; and they direct the flow of cooling air through the
chassis. Do not operate the system unless all cards, faceplates, front covers, and rear covers
are in place.
Auto-boot—The embedded operating system initializes and displays basic information.
Configuration menu—A 6-second countdown allows you to enter the configuration menu.
Initialization—The gateway completes its boot sequence and is ready for operation.
Chapter 2
Installing the Cisco Unified Videoconferencing 3545 Gateway
OL-14912-01
Advertisement
Table of Contents
