Advertisement
Section 3
3.3 WAVE DESIGN PROCESS
The wave design process is a series of operations that allows you to quickly modify a standard
waveform to fit your specific welding application. The following process flowchart applies to a
pulse waveform, but is similar to the process used to modify STT and other waveforms.
Examples of each process step can be found in the listed reference paragraphs.
Save File to Disk
Download File to Welding
Machine Memory
SOFTWARE OPERATION
PROCESS FLOW:
Select a Waveform
from Memory
Mode = OFF
Select Workpoint
Set Powerwave WFS
Set Trim = 1.00
Set Arc Control = OFF
Adjust Pulse
Variables at
Fixed Stickout
Adjust Peak Volts
and
Adaptive Type
Adjust Optional
Variables
(if needed)
GO FIGURE
WAVE DESIGNER
Set NO-ADAPT
Set ADAPT
GO FIGURE
REFERENCE
PARAGRAPH:
(SEE APPENDIX A)
A-4.1
A-4.2 Step 1
A-4.2 Step 2
A-4.2 Steps 3 & 4
A-4.2 Steps 5, 6, & 7
A-4.2 Step 8
Section 3, paragraph 3.4
3-11
27850021
Advertisement
