Writing Method Using User Mode; When Optical In Terminal Is Used - Yamaha RX-V1800 Service Manual

RX-V1800/HTR-6190/DSP-AX1800

Writing method using USER mode

G Required tools
• DVD or CD Player with DIGITAL OUTPUT (OPTI-
CAL or COAXIAL) terminal
• Optical cable (when OPTICAL terminal is used)
• Digital audio pin cable (when COAXIAL terminal is
used)
• Latest firmware CD
* To make the latest firmware CD, download the
latest firmware from the specified download
source.
G Operation procedures
* Disconnect the power cable of the main unit and
DVD/CD player from the AC outlet.
1. Connect the main unit and DVD/CD player as shown
below. (Fig. 16)

When OPTICAL IN terminal is used /

Main unit /
2. Reconnect the power cable of DVD/CD player to
the AC outlet.
3. Press the "MASTER ON/OFF" key of the main unit
while simultaneously pressing the "STRAIGHT"
key of the main unit. Then the ADVANCED SETUP
mode is activated. (Fig. 17)
4. Press and hold the "SLEEP" key for about 3 sec-
onds. (Fig. 17)
<CDDA Upgrader 1800> is displayed.
32
Optical cable
Fig. 16
DVD/CD player /