Yamaha RX-V1800 Service Manual page 25

G Operation procedure
• Writing to MAIN and VIDEO
1. Start up "DSP_FLASHER_Vx800_v1.0.exe" of
the PC. (Fig. 5)
2. Select "Main/Video". (Fig. 5)
3. Select the model name of the receiver, the
Micom, Com Port and file. (Fig. 6)
Model : Select "V1800".
* Select "V1800" also for HTR-6190.
Micon : Select "MAIN" for writing to MAIN .
Select "VIDEO" for writing to
VIDEO.
Com Port : Select the RS232C port (COMx)
set on the PC side and press the
[connect] button, and <connected>
will appear as "Com Port status".
* If <connected> does not appear as "Com
Port status", check the setting on the PC
side again if the RS232C port (COMx) is
selected properly.
File : Select the firmware.
Writing to MAIN
: Select "V18Mxxxx.mot".
* Select "V18Mxxxx.mot" also for HTR-6190.
Writing to VIDEO
: Select "V18Vxxxx.mot".
* Select "V18Vxxxx.mot" also for HTR-6190.
Fig. 5
Press [open] button to open the window
Select the port of RS-232C to use and press the [connect] button
Select the model name of main unit
Fig. 6
4. Press the [RDY] button. (Fig. 7)
The connection ready state will be set.
Fig. 7
RX-V1800/HTR-6190/DSP-AX1800
Select the Micom
Select the firmware
25