Sharp FACSIMILE FO-4500 Service Manual page 13

5
Insert the protruding connector on the PC interface board into the
hole in the metal flange on the frame as shown, and secure it with
two hex bolts.
Remove the connector cover. Secure the interface board to the
frame with the screw as shown. Connect the cable to the interface
board and the main board. Insert the cable into the plastic band
directly above the interface board.
6
Remove the seal covering the hole in the side cover.
7
Replace the side cover. Make sure that the tabs on the bottom
edge insert upward into the holes in the frame, and make sure
that the tab on the side of the cover inserts into its hole.
8
Replace the paper tray, making sure that the top edge of the side
panel fits upward into the groove on the front, bottom edge of the
tray.
9
Replace the three screws in the paper tray as shown, and then
close the paper tray.
F
Replace the five screws as shown.
G
Insert the male end of the PC interface cable into the port on the
right side of fax as shown. Tighten the attached screws with a
screwdriver.
H
Insert the female end of the PC interface cable into the serial
(RS-232C) port on your computer.
Tighten the attached screws with a screwdriver.
I
Set Option Setting 32 to YES to enable the PC connection. Set
Option Setting 33 to select whether incoming documents will be
received in the computer or printed out by the fax.
1 – 11
FUNCTION
4
3 2
4
START
FO-4500H