Lexmark CX510 Series User Manual page 149

Understanding the printer menus
Use
Allow Background Removal
On
Off
Allow Custom Job Scans
On
Off
Scanner Jam Recovery
Job level
Page level
Web Page Refresh Rate
30–300
Contact Name
Location
Alarms
Alarm Control
Cartridge Alarm
Timeouts
Standby Mode
Disabled
1–240
To
Specify whether image background removal is allowed.
Note: On is the factory default setting.
Scan multiple jobs to one file.
Note: On is the factory default setting. If On is selected, then the
Allow Custom Job Scans setting can be enabled for specific jobs.
Specify how a scanned job should be reloaded if a paper jam occurs
in the ADF.
Notes:
•
Job level is the factory default setting. If Job level is selected,
then rescan the entire job.
•
If Page level is selected, then rescan from the jammed page
forward.
Specify the number of seconds between Embedded Web Server
refreshes.
Note: 120 is the factory default setting.
Specify a contact name.
Note: The contact name is stored on the Embedded Web Server.
Specify the location.
Note: The location is stored on the Embedded Web Server.
Set an alarm when the printer requires user intervention.
For each alarm type, select from the following options:
Off
Single
Continuous
Notes:
•
Single is the factory default setting for Alarm Control and
Cartridge Alarm. This sounds several quick beeps.
•
Continuous repeats several quick beeps in a regular interval.
Set the amount of time before the printer enters a lower power
state.
Note: 15 minutes is the factory default setting.
149