Configuring The System - Lincoln Electric POWER WAVE 455 M Operator's Manual

A-6

CONFIGURING THE SYSTEM

For codes below 11100, consult the semi-automatic
Power Feed instruction manual for configuration infor-
mation about DIP switch settings.
For codes above 11100 the power source will "Auto
Map" the system eliminating most of the need to set
DIP switches to configure the system.
SINGLE HEAD FEEDER
POWER WAVE
455M(CE)
SINGLE HEAD BOOM FEEDER
Typical Robotic/ Hard Automation
(using Wire Drive Module and PF-10R)
INSTALLATION
UP TO 4 FEEDERS
ALLOWED
POWER WAVE
455M(CE)
ROBOT
PLC CONTROLLER
ANALOG INTERFACE
etc.
POWER WAVE 455M (CE)
If a system can not be "Auto Mapped" then the status
light on the power source will blink green fast and the
welder output will be disabled. If a system is not
"Auto-mappable", then consult the instruction manual
for the accessory being used for configuration infor-
mation about DIP switch settings, or consult your local
Lincoln sales representative.
DUAL HEAD FEEDER
POWER WAVE
455M(CE)
UP TO 4 FEED HEADS
ALLOWED
FH 1
POWER WAVE 455M(CE)
WIRE
DRIVE
MODULE
A-6
FEED HEAD
PF-10R