Configuring The System - Lincoln Electric Power Wave 455M Operator's Manual

A-6

CONFIGURING THE SYSTEM

The power source will "Auto Map" the system
eliminating most of the need to set DIP switches to
configure the system.
SINGLE HEAD FEEDER
POWER WAVE
®
455M
SINGLE HEAD BOOM FEEDER
SINGLE HEAD BOOM FEEDER
INSTALLATION
UP TO 4 FEEDERS
ALLOWED
POWER WAVE
®
455M
ROBOT
PLC CONTROLLER
ANALOG INTERFACE
etc.
POWER WAVE
If a system can not be "Auto Mapped" then the status
light on the power source will blink green fast and the
welder output will be disabled. If a system is not
"Auto-mappable", then consult the instruction manual
for the accessory being used for configuration
information about DIP switch settings, or consult your
local Lincoln sales representative.
DUAL HEAD FEEDER
POWER WAVE
®
455M
UP TO 4 FEED HEADS
ALLOWED
FH 1
®
POWER WAVE 455M
WIRE
DRIVE
MODULE
455M
®
A-6
FEED HEAD
PF-10R