Accessories; Drive Roll Kits; Alternative Magnum Gmaw Gun And Cable Assemblies; Magnum Gun Connection Kit - Lincoln Electric POWER MIG 255 SVM144-B Service Manual

C-2

DRIVE ROLL KITS

Refer to Table C.1 for various drive roll kits that are
available for the POWER MIG. All items in Bold are
supplied standard with the POWER MIG.
TABLE C.1 — AVAILABLE DRIVE ROLL KITS.
Wire Size
0.023-0.030 in. (0.6-0.8 mm) KP1696-030S
Solid
0.035 in. (0.9 mm)
Steel
0.045 in. (1.2 mm)
0.035 in. (0.9 mm)
Cored
0.045 in. (1.2 mm)
Aluminum 3/64 in. (1.2 mm)
3/64 in. (1.2 mm) ALUMINUM
FEEDING KIT (K1703-1)
This kit helps push feeding aluminum through standard
machine feeder and gun. It provides gun and wire drive
conversion parts to
(1.2 mm) aluminum wire. 5356 alloy aluminum wire is
recommended for best push feeding performance.
Kit includes drive rolls and wire guide plate for the wire
drive, liner and two contact tips for the gun, along with
installation instructions.
K363P READI-REEL ADAPTER
The K363P Readi-Reel adapter mounts to the
2 in. spindle. It is needed to mount the 22-30 lb Readi-
Reels.
DUAL CYLINDER
MOUNTING KIT (K1702-1)
Permits stable side-by-side mounting of two full size (9
in. dia. x 5 ft. high) gas cylinders with "no lift" loading.
Simple installation and easy instructions provided.
Includes upper and lower cylinder supports, wheel
axles and mounting hardware.

ACCESSORIES

Drive Roll Kit
KP1696-035S
KP1696-045S
KP1697-035C
KP1697-045C
KP1695-3/64A
weld with 3/64 in.
POWER MIG 255
ALTERNATIVE MAGNUM GMAW
GUN AND CABLE ASSEMBLIES
The following Magnum 250L gun and cable assemblies
are separately available for use with the POWER MIG
255. Each is rated 200 amps 60% duty cycle (or 250
amps 40% duty) and is equipped with the integrated
connector, twist-lock trigger connector, fixed nozzle
and insulator, and includes a liner, diffuser, and contact
tips for the wire sizes specified:
Length Part No.
10 ft (3.0 m) K533-1
*12 ft (3.6 m) K533-7 0.035 – 0.045 in. 0.9 – 1.2 mm
15 ft (4.5 m) K533-3
*Fixed Nozzle

MAGNUM GUN CONNECTION KIT

(Optional K466-6)
Using the optional K466-6 Magnum Connection Kit for
the POWER MIG permits use of standard Magnum
200, 300 or 400 gun and cable assemblies.
TIMER KIT INSTALLATION
(Optional K1701-1)
The timer kit adds selectable 4-step trigger interlock,
spot and Run-In functions and manual adjustment of
burnback time. Install as follows, or per the instructions
included with the kit:
WARNING
Remove all input power to the POWER MIG 255
before proceeding.
------------------------------------------------------------------------
1. Verify that the following items have been included
in the kit:
a. Timer board with harness and panel
assembly.
b. Two screws.
2. Turn the power switch off and disconnect power
from the machine to prepare for kit installation.
C-2
English Wire Metric Wire
Size Size