Lincoln Electric LN-9 SVM127-A Service Manual page 125

F-67
DRIVE MOTOR REMOVAL AND REPLACEMENT (continued)
MYLAR
INSULATOR
GLASTIC
MOUNTING
BOARD
13. Lift the right side cover assembly and care-
fully lift and slide the motor and wire drive
assembly partially out of the LN-9 box
assembly. See Figure F.27.
TROUBLESHOOTING & REPAIR
FIGURE F.27 – MOTOR AND WIRE DRIVE REMOVAL
MOUNTING
BOLTS (4)
LN-9 Wire Feeder
14. Using the 1/2" wrench, remove the four bolts
and associated washers holding the glastic
mounting board and mylar insulator to the
gear box assembly.
NOTE: Four-roll drive units will require the
removal of a 1/2" bolt mounting the reed switch
copper energizer to the glastic plate.
F-67