Cleaning The Racing Wheel - Porsche 911 GT3 RS Owner's Manual

CLEANING THE RACING WHEEL

Clean only with a dry or slightly damp cloth. Using
cleaning solutions may damage your racing wheel.
TROUBLESHOOTING
The Porsche GT3 RS Wheel must not be opened or
®
modifi ed. ENDOR AG expressly prohibits analysis and
utilisation of the electronics, hardware, software and
fi rmware contained in the controller.
In case diffi culties occur in connection with utilisation of
the Porsche Wheel, please use the following guide for
elimination of errors.
On the website www.FANATEC.com
details and contact data.
Malfunctions on Playstation 3
Game does not recognize the Porsche wheel:
Please switch the wheel to compatibility mode.
Saving the game is not possible:
Set back the system date of the Playstation 3 to any
date before December 2008.
Please make sure that your game supports this feature.
Clutch or 6-speed gear shift is not working at all
• Please make sure that your game supports this
feature.
• Please check if you have chosen the right settings
Pedals are not working properly
In case one axis is always active, disconnect the pedals
so that the pedals recalibrate themselves.
Wheel is not working properly
you will fi nd further
Force Feedback strength gets weaker
Under certain circumstances it can happen that the
Force feedback Motor of the wheel might be in danger to
overheat. The built in temperature sensor will automatically
reduce the power of the Force Feedback effects until the
normal operating temperature is reached.
24
in the options menu of the game.
• In GT5: Prologue you need to press the triangle
button to activate the clutch.
• Please make sure that the gear stick cable is con-
nected properly.
• Please make sure that the gear stick is calibrated.
• Please check if the game is supporting the wheel
and if you selected the right settings in the options
menu of the game.
• Make sure the latest version of the Porsche wheel
driver is installed (PC only).
• Please make sure that the power cable is connected
properly. After the wheel is connected it should
automatically self calibrate.