Table of Contents
Advertisement
11. Press [ENTER] to edit the time needed, the display shows " TXXX" , " XXX" stands for
the time needed to run the current scene, value " 001-999" . E.g., " 002" means you
need 0.4ms (002*0.2ms) to run the current scene. Adjust the desired time by
pressing [UP] or [DOWN] button.
12. Press [ENTER] to save the settings for the scene you are editing, the display will
change to the next scene automatically.
13. Repeat steps 3-14 to edit and other scenes, you can edit and save a maximum of 48
scenes.
14. Press [MENU] to exit. The number of steps can be defined under " STEP" and
the scenes can be called up under " RUN"
Step 1B – Building Scenes from an External DMX Controller
The fixture includes a simple built-in DMX recorder. This recorder allows you to build a
scene using your own DMX console. That scene can then be sent to the fixture and be
stored inside one of the fixture' s scene storage banks. Many people may find this procedure
easier and quicker than using the on board menu functions as in " Step 1." To store a scene
from an external DMX controller follow the procedures below:
1. Select " SC01" by pressing [UP] or [DOWN] button.
2. Press [ENTER], the display shows " SC01" .
3. Press [ENTER], the display shows " C-01" .
4. Select "CNIN" by pressing [UP] or [DOWN] button.
5. Press [ENTER], the display shows "OFF".
6. Press [UP] or [DOWN] button .the display shows "ON".
7. Press [ENTER], the display shows "SC02". You successfully downloaded the first
scene.
8. Adjust the Step-time as described above under point 12.
9. Call up the second scene in your controller now.
10. Repeat steps 5 -11 until all desired scenes are downloaded.
11. Press [MENU] to exit. The number of steps can be defined under " STEP" and
the scenes can be called up under " RUN" .
©Elation Professional, Los Angeles Ca.
33
DLED Par Zoom
www.ElationLighting.com
™
Advertisement
Table of Contents
