Dmx Addressing; Remote Dmx Addressing (Rdmx) - Elation DLED Par Zoom Manual

10. DMX ADDRESSING

Setting the DMX address - After the fixture is turned " ON" it will immediately complete a
reset process that test all the fixture' s functions. When the reset process concludes the LCD
will display the fixture' s current DMX address. If the fixture is not receiving a DMX signal, the
display will flash continuously. To set or adjust a DMX address, please follow the procedure
below:
1. Toggle through the menu by pressing the Up and Down buttons until the display
reads " Addr=XXX." Tap the enter button to make changes to the address.
2. While the display is flashing use the " UP" and " DOWN" buttons to select a new
address. Once the new address has been selected, lock the new address into
the fixture' s memory by pressing the " ENTER" button.
The DMX address is non-volatile and will remain in the fixture' s memory even when the
power to the unit is switched off. Memory is backed-up and retain by an internal power
source that should last about five years
Remote DMX addressing (RDMX) / Address Via DMX- This function allows the DMX
address to be changed remotely from a DMX console. This setting requires special settings
for both the controller and the fixture. This function may be turned on and off, and is " ON" be
default. Follow the p rocedure listed below to access the RDMX functions:
Fixture Settings:
1. Access the main menu and use the UP or DOWN to get to the " MODE"
menu, then press ENTER
2. Once in the " MODE" menu, tap the UP or Down to get to the
" ADDR" menu, press ENTER.
3. Once in the " ADDR" menu tap the UP or Down to get to the " RDMX"
function and press ENTER.
4. " RDMX" is the function that turns the RDMX function on and off. Press
ENTER and be sure the function is turned on.
5. Press the UP button to display " ON" to activate this function, or " OFF" to
deactivate this function.
©Elation Professional, Los Angeles Ca. 25
DLED Par Zoom
www.ElationLighting.com
™