Lincoln Electric IDEALARC SVM136-A Service Manual page 91

F-51
MAIN TRANSFORMER REMOVAL & REPLACEMENT (continued)
INSULATION
10. Mount the primary thermostat to the lead
end coil nose. See Figure F.30. Place a
small amount of Lincoln Electric E1603
Epoxy between the coil nose and the coil
insulation and between the insulation and
the thermostat.
place with E2381 (.375" wide) tape. If nec-
essary, after assembly protect the thermo-
stat terminals with E2547 terminal boots.
FIGURE F.31 – SECONDARY LEAD TRIM AND WELD DETAIL
TROUBLESHOOTING & REPAIR
FIGURE F.30 – PRIMARY THERMOSTAT LOCATION
Hold the thermostat in
TIG WELD
IDEALARC CV-400
TOP VIEW
THERMOSTAT
FRONT VIEW
11. If necessary, trim off excess secondary lead
stickout and TIG weld the leads together.
See Figure F.31.
F-51