Lincoln Electric COMMANDER SVM145-B Service Manual page 94

F-38
SCREWS
FRONT
CONTROL
PANEL
TEST PROCEDURE
1. Turn the engine off.
2. Using the 3/8" wrench, remove the four
screws holding the front control panel to the
case top and sides. See Figure F.14. (There
are two screws on the top and one screw on
each side.)
TROUBLESHOOTING & REPAIR
STATOR VOLTAGE TEST (continued)
FIGURE F.14 – FRONT CONTROL PANEL REMOVAL
COMMANDER 300
SCREW
3. Carefully lower the front control panel.
4. Using the 3/8" wrench, remove the front left
and right side panels.
5. Using the 3/4" wrench, remove the internal
leads from the output terminals. Insulate the
leads.
F-38