Disassembly Instructions; Terminal With Locking Mechanism" Detaching Points; Removing The Cabinet - Mitsubishi Electric MXZ-2A40VA Service Manual

14

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
14-1. MXZ-2A40VA
MXZ-2A52VA
OUTDOOR UNIT
OPERATING PROCEDURE

1. Removing the cabinet.

(1) Remove the screw fixing the service panel. (See Photo 1.)
(2) Pull down the service panel and remove it. (See Photo 1.)
(3) Disconnect the power supply and indoor/outdoor connecting wire.
(4) Remove the screws fixing the top panel. (See Photo 1.)
(5) Remove the top panel. (See Photo 1.)
(6) Remove the screws fixing the cabinet.
(7) Remove the cabinet.
(8) Remove the screws fixing the back panel.
(9) Remove the back panel.
1Slide the sleeve.
2Pull the terminal while
pushing the locking
lever.
Photo 1
Screws
of the
top panel
Screws of
the cabinet
77
(2) The terminal with this connector has the
locking mechanism.
1Hold the sleeve, and
pull out the terminal
slowly.
Connector
PHOTOS
Screw of
Screws of
the cabinet
the top panel
Back
Screw
panel
of the
service
panel
Direction to
remove
Hooks
Service
panel