Mounting The Kombitool; Adjusting The Cutter Bar - Stihl HL-KM Instruction Manual

English
2
4
Once the end of the drive tube is
inserted beyond the slot in the clamp (4):
Push the gearbox (2) fully home as
N
far as stop.
Tighten down the clamp screws
N
moderately.
Line up the gearbox (2) on the drive
N
tube so that the machine support on
the engine points down and the
blades are horizontal.
Tighten down the clamp screws
N
firmly.
12

Mounting the KombiTool

2
1
Push the lug (1) on the drive tube
N
into the slot (2) in the coupling
sleeve as far as stop.
3
4
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
Tighten down the star knob (4)
N
firmly.
Removing the KombiTool
Reverse the above sequence to
N
remove the drive tube.

Adjusting the Cutter Bar

135° Version
The angle of th cutter bar can be
adjusted upwards in 4 stages from 0°
(straight) to 45°, and downwards in 8
stages from 0° to 90° (right angle facing
down). There are therefore 13 possible
working positions.
There is also a special transport position
for the cutter bar.
WARNING
To reduce the risk of injury, carry out the
adjustment only when the cutting blades
are at a standstill – engine at idle speed.
HL-KM